[ad_1]
A centrifugal pump uses a rotating impeller to increase liquid velocity in a piping system. It was first documented in 1475 and modern pumps were developed in the late 1600s. The force is created through rotational kinetic energy from an electric motor. Resistance must be created to slow down the flow of a liquid. There are seven different types of pump heads. The amount of power required depends on the specific gravity of the fluid.
A centrifugal pump increases the velocity of a liquid in a piping system using a rotating impeller. An impeller is built into the pump itself and is responsible for transferring the liquid through the pump. This type of pump is most commonly used in connection with a liquid piping system and can be found in a manufacturing, water treatment or food processing plant environment. The centrifugal pump is documented for the first time in 1475 in the writings of Francesco di Giorgio Martini. Modern pumps were developed in the late 1600s by Denis Papin.
The force behind the pump is created through the use of rotational kinetic energy from an electric motor. As the pump impeller rotates, it creates energy which allows the liquid to be drawn towards the center of the impeller and then pushes it out again. This pressure causes a pressure increase further downstream in the pipe, forcing the liquid to flow. An impeller is just like a propeller, but without the blades.
To slow down the flow of a liquid, resistance must be created. When the centrifugal pump body captures the liquid and controls its flow, it slows down the kinetic energy and converts it into pressure energy. It is important to remember that pressure is a measure of resistance to flows and is not created by the pump.
Sometimes, the discharge from the centrifugal pump is pointing up. Under these circumstances, liquid is pumped, but only to a predetermined height. This height is called the closing head and is limited by the diameter of the pump impeller and the rotation speed of the pump itself.
There are seven different types of pump heads in a centrifugal pump: full static, full dynamic, static suction, static lift, static discharge, dynamic suction, and dynamic lift. Pump head is measured in imperial or metric measurements and can be found at a variety of hardware stores. All fluids will be pumped to the same height as long as the centrifugal pump shaft exerts the same level of effort.
The only adjustment required when changing the liquid in the pump is the amount of power required. To determine whether more or less horsepower is needed, check the specific gravity of the fluid. The higher your score, the more power you’ll need to generate to get the same amount of height.
[ad_2]