[ad_1]
A drill gauge is a tool used to determine the size of a drill bit, with holes representing various sizes. Bit sizes are based on diameter and can be metric or fractional. Drill bits were traditionally sized using a gauge system. Builders can use a drill gauge to size a fastener or determine which bit to use. A homemade drill gauge can be made from a block of wood.
A drill gauge is a device used to identify the size of a drill bit. It can be made from steel, aluminum, plastic, or wood, and contains a series of holes representing bits of various sizes. Each hole is marked with a size according to its size. These measurements can be engraved on the drill gauge or stamped on the top.
To understand how a drill gauge works, it helps to understand how drill bits are sized. A bit size is based on the diameter of the bit and is available in both metric and fractional units. Metric drill bits are typically used in countries that use the metric system, while fractional size drill bits are used in the United States and other countries that don’t typically use the metric system.
Traditionally drill bits were sized using a gauge system, which is similar to today’s wire gauge system. Drill sizes were given by number, from 80 to 1, then by letter from A to Z, resulting in 106 different bit sizes. The smallest bits were those listed as 80 gauge, while the largest were Z-gauge. While gauges can still be found on some drill bits, metric or fractional sizing is far more common.
A drill gauge sizing tool can contain gauge dimensions along with the fractional and metric equivalent. Others may only contain standard metric or fractional measurements. While gauge sizing is less common today, the drill bit gauge measuring tool gets its name from this sizing system.
Builders can use a drill gauge for a wide variety of applications. It can provide the size of a bit or it can be used to size a fastener to determine which bit should be used with it. When using a drill gauge, it’s important to understand that the tip of a drill bit is usually smaller than the rest of the body. To get an accurate measurement, insert the entire tip into the hole inside the gauge until you find the hole that best represents the tip size.
Many carpenters and builders make their own drill gauge using a block of wood. To get started, choose a piece of wood large enough to fit all of the bits in your drill kit. Drill holes in the wood to represent each individual piece. After all holes have been drilled, mark each hole with the appropriate gauge or measurement depending on which system you are most comfortable with.
[ad_2]