[ad_1]
Capacitors store and release energy quickly, making them useful in car audio setups. To charge a capacitor, connect it to a power source via a resistor or light bulb. When charging, be cautious as a charged capacitor can release a large amount of power quickly and can be dangerous.
Capacitors are devices that store energy and release it in quick bursts. While batteries take a relatively long time to charge and can discharge over a long period of time, charging a capacitor can sometimes take only a second, and discharging can happen in a fraction of a second. Accessory capacitors are often used as storage cells in car audio to aid power amplifiers that need to drive subwoofers with strong bass signals.
To charge a capacitor, it must be connected to a power source via a resistor or a light bulb, usually included with the capacitor, to control the flow of energy. Connect one end of the resistor or light bulb to the positive terminal of the capacitor, then connect a ground wire to the negative terminal of the capacitor. To actually charge a capacitor, connect a wire from the positive terminal of the battery or power source to the resistor or light bulb and hold it there until the capacitor is charged, usually indicated by the light bulb going completely out. A very safe way to do this is to have a fuse between the battery and the capacitor which you can remove as you work with the wiring.
If you want to charge a capacitor in a car audio setup with an amplifier, the wiring will look pretty much the same. Instead of connecting the battery and ground directly, you’ll install the capacitor between the battery and the amp. The positive wire should go from the battery to the capacitor and an extra wire should go from the capacitor’s positive terminal to the positive power terminal on the amplifier. On the negative side, connect the amplifier’s negative terminal to the capacitors, then run an extra wire from the capacitor to ground.
When charging a capacitor, remember the danger inherent in the process. A fully discharged capacitor is harmless. Once charged, however, it can release a large amount of power in a very short time. It’s very easy to get shocked, which makes it crucial that you never connect across both of its terminals. While car audio capacitors typically don’t carry enough voltage to be dangerous in dry conditions, they can be dangerous if their terminals or your hands are wet. Other high-power capacitors, including those in computer power supplies and old televisions, can be lethal if touched when charged.
[ad_2]