Repairing car paint chips involves buying matching paint, washing the car, applying primer and several thin coats of paint, and blending the edges of the repair. Getting the color right is vital, and a paint chip repair kit can be used. The final step involves using super fine sandpaper to level the surface of the repair.
Repairing car paint chips is a slow process, but it will help preserve the appearance and value of your car. Start by buying paint that matches the color of your car as closely as possible and collect the necessary supplies. The car needs to be washed and the paint chips on the car need to be cleaned and prepared for the repair process. Once the area is clean, the primer is applied in several thin coats and allowed to dry between applications. Numerous coats of paint are then applied until the repair is even with the rest of the car’s finish. The process is completed by blending the edges of the repair and waxing and polishing the area.
In order for car paint chips repair to blend well, getting the color right is vital. In general, the best way to do this with a newer model vehicle is to contact the dealer for the factory paint color for your car. You may be required to provide the paint code, which should be located on a sticker somewhere on the vehicle, usually on the inside of a door or under the hood. With older vehicles, aftermarket paint may be available at an auto parts and supply store. Once you have the paint, you need to gather other supplies for the repair process, such as solvent, primer, very fine sandpaper, and polish. An easier alternative is to purchase a paint chip repair kit, which should contain most of the supplies you need.
Once you’ve gathered the necessary supplies, wash the car thoroughly, paying particular attention to areas where paint chips are found on the car. As an option, the area inside each paint chip can be sanded smooth to provide a rough surface for the new paint to adhere to. Areas to be repaired should also be lightly cleaned with a solvent to ensure there is no residue. It is also important to make sure that there is no rust; If any are found, they should be cleaned before beginning the repair.
If your car’s paint chips have exposed metal, the next step is to apply primer. Approximately two or three very thin coats should be applied with drying time between each coat. A recommended technique is to apply the primer with a toothpick or the paper end of a match, allowing it to flow slowly over the surface to be covered. Cover the repair area with a box and allow it to dry for at least two hours, then apply another coat using the same technique. Once the primer is dry, it’s time to paint.
When applying paint to car paint chips, several thin coats are better than one thick one. It is recommended to apply paint with the same method used for the primer; apply as many coats as necessary to make the repair slightly higher than the rest of the vehicle’s finish. Eight to 12 coats may be needed; The area should be covered with a box and allowed to dry between each coat. Once the paint application is complete, it should be allowed to dry for at least a week.
The final step in the repair is to use 2000 grit super fine sandpaper to level the surface of the repair. A tool called the Finesse Block is recommended; it will not leave scratches and will only remove the raised part of the repair. Similar to using a wooden plane, it should be used wet and drawn smoothly across the surface going in only one direction.
Protect your devices with Threat Protection by NordVPN
