[ad_1]
Radio masts are steel structures used by radio stations to support broadcasting equipment. Radiation masts are broadcasting equipment and can transmit and receive signals without additional equipment. Masts are constructed with tubular and angle-cut steel and supported by “guys”. They are named after the surrounding area or the station they support.
A radio mast is a vertically designed steel structure used by radio stations around the world. Radio masts are used to support the broadcasting equipment needed by the station to transmit signals to listeners and different repeater stations. There are also several towers called radiation masts which closely resemble typical radio masts.
It is important to distinguish the radio mast from the radiation mast. While radio antennas support equipment, radiation antennas are actual broadcasting equipment. Radiation masts can be used as both a transmitting antenna and a receiving antenna. They do not require the installation of transmission equipment, which is beneficial in preventing tower sagging and mast collapse due to weight and wind resistance.
The construction of a radio mast typically consists of tubular and angle-cut steel. The steel angle forms the vertical support pieces. The tubular steel is welded or bolted into a lattice between the angled supports.
Some masts are built to resemble straight towers, with little or no visible angles designed into the rise of the tower. Others are designed with a wider base at ground level, tapering as the tower grows in height. These towers are typically used for television broadcasting equipment, as the devices used to broadcast television signals are usually much larger and heavier than radio broadcasting equipment.
There are also different support methods used for radio antennas. The methods used to support a radio mast are usually referred to as “guys”. These types are used on each side of the radio mast and can be used for both the top and bottom of the radio.
You can also hook the kids to the top portion of the radio mast and allow them to support the entire structure itself. Alternatively, guy lines can be attached to the structure at the mid-mast joint and run to the ground. This leaves the top half of the tree an independent unit. Regardless of how they’re attached, however, radio antenna mast supports run diagonally from the mast to the ground, where they’re attached to concrete blocks used to keep them from shifting or loosening.
Naming of trees or towers is usually done according to the area surrounding the tree itself. Such trees are most commonly named after the city or town where the tree is located. Some masts are also simply named for the radio station or television broadcasting network they were built to support.
[ad_2]