Thread angle is the degree of angle between the threads on a screw, affecting its fixing power and ease of installation. Standard angles include 60 degrees for most screws, 55 degrees for pipes, and 30 degrees for rounded or knuckle threads. The angle can be measured using a micrometer or calculated based on other screw measurements.
Thread angle is a measure of the degree of angle between the individual threads on a screw. These threads are teeth or cuts made in the shank of a screw or bolt. By cutting the teeth at an angle, manufacturers can improve the fixing power of the screw. Changes in thread angle also determine how easily the screw can be installed in certain types of material. Based on these factors, contractors consider angle when selecting screws to find the best types of fasteners for each application.
Many types of screws are cut to a standard angle, which is based on industry standards for that type of fastener. For example, most V-thread screws are cut at a 60 degree angle to each other. This is true for all fasteners used in the United States. and the UK, as well as all other countries that rely on the Unified Thread Standard or UTS. This 60 degree angle is usually identified by the letter M, found on screw packages and screw identification charts. A 60 degree angle was chosen because it provides a balance of holding power and ease of installation for the widest number of projects.
Most metal and plastic pipes have a 55 degree thread angle, which serves as the industry standard for pipes under the UTS. These tubes feature an angle identification of G, which is associated with a 55 degree angle. Some bolts and specialty fasteners may also use a 55-degree angle, which is based on the traditional Whitworth screw identification system. These fasteners are identified by the letter W and can include screws and bolts used on bicycles and some specialty vehicles.
Screws with a rounded or knuckle thread design typically have a 30-degree angle. This low angle is also used on Acme or square tooth threads as well as trapezoidal threads. Reinforced threads, which have one square side and one angled side, typically have an angle of between 30 and 45 degrees. All fasteners with full square thread are considered to have zero angle.
Users can measure the angle of the thread using a special tool known as a micrometer. You can also calculate thread angles based on other screw measurements, such as thread diameter or the number of threads per inch. Based on this information, screw manufacturers can determine how many threads are needed and where to make the cuts along the shank to achieve the desired angle.
Protect your devices with Threat Protection by NordVPN
